AV Automation can send commands to all connected broadcast devices. For the commands to be received, and interpreted according to the device's specifications, the device must be configured within Viz Mosart.

• To configure device properties in AV Automation, select Devices > Properties.

The Device Properties menu has three common buttons:

• Cancel: Exit this menu without saving any changes.

• Apply: Save all changes and reconnect the device on the active tab (only applies to tabs Vision Mixer, Video Servers, Graphics, Audio, Camera Robotics, Light Control and Subtitles).

• Save & Close: Save all changes and close the menu.

This section presents the following device properties:

• Vision Mixer
• Video Servers
• Graphics
• Audio
• Camera Robotics
• Light Control
• Router
• Subtitles
• GPIIO
• Tally
• Virtual Set
• Weather
• Video Wall
• General
• Vizrt Graphics