Service Host Administrator Guide

Version 1.2 | Published January 23, 2019 ©

Hardware and Software Requirements

Hardware Requirements

Channel Recorder runs on the following hardware:

  • HP Z840

  • Dell R7910 (2U) Rack Server

The Viz Engine Administrator Guide provides a detailed description of these machines.

Note: To be able to achieve maximum performance using Channel Recorder, Hyperthreading should be enabled. This is located in the BIOS.

Channel Recorder requires one of the following video boards:

Video Boards

Recording capability

Matrox X.mio3

SDI

Matrox DSX LE4

SDI

Matrox X.mio3 IP

2022, 2110

Matrox DSX LE4 IP

2022, 2110

Matrox M264

RTP/H264

DSX.Core

RTP/H264

Note: All the above boards should be upgraded to enable recording with different codecs. To check which upgrades the board has available, use the Matrox Utils in the task bar and check if the board has 500 or 550 upgrade applied (for ProRes). If the board does not have this upgrade, this must be ordered. Additionally, to receive RTP/H264 the Matrox M264 must have the RTP upgrade. Refer to Recording RTP/H264 Stream for more information.

images/download/attachments/44370948/tempsnip.png

Note: The DSX.Core is not technically a physical board and is used to to receive and record RTP/H.264 streams. Refer to Recording RTP/H264 Stream for more information.

Note: The M264 encoder/decoder board is required for CPU intense codecs like XAVC and ProRes. It is mandatory for UHD recording and strongly recommended for ProRes and AVC codecs.

To Upgrade Class and Firmware

To upgrade your Matrox board, for example to enable more IO-ports or a codec upgrade for HD recording, you must use the mvDongleUpdater.exe update utility with your Vizrt supplied license upgrade file <filename>.OPT. This utility is installed with the Matrox driver package and will normally be installed to:

C:\Program Files\Matrox DSK.utils\drivers\mvDongleUpdater.exe

To upgrade the card use this syntax:

C:\Program Files\Matrox DSX.utils\drivers\mvDongleUpdater.exe upgrade -sn="BoardSerialNumber" -f="Path to the upgrade file"

The command above must be run from a Windows command line window.

Software Requirements

Channel Recorder 1.3 requires Matrox DSX.utils version 9.9.1.23136.

In most cases, a system with a configured and reliable NTP server is necessary. This is particularly important when working with other components such as Viz Dart or Viz One, in which case they should all use the same NTP server.

See Also